Why the Led or LCD screen doesn’t work?
Maybe the buttons are blocked by stickers, or the screws on the back of the display board are tightened too much, so the buttons are blocked. Please try loosening the screws a little, especially the one near the function buttons. This will allow the function buttons to work properly, and then you can switch between slush mode and juice mode.
The guided steps are as follows:
* Unscrew the screws and remove the metal door to reveal the display panel.
* Loosen the three screws.
*Please restore the machine to factory settings.
Please kindly try, If it still doesn’t work, could you please kindly send a short video to us at Service@callsupport.com to check
Related Articles
Why does the fan of my machine not work?
To confirm the issue in detail, could you please kindly help us confirm the following information? Wondering if the fan wiring is connected correctly? If it still don’t work, Wondering if you can take a short vide for us at services@callsupport.com ...
Why does my machine not work and light is off?
To confirm the issue in detail, could you please kindly help us confirm the following information? 1. Check cable and wire connections. 2. Check the wiring of the gear switch and wiring cap to ensure that the wiring is firm. 3. Replace with a new ...
Tank A is not working but augerturning, the indicator light on A is off, and there is no ice.
1. Please do factory reset as video and check when do factory reset ,when A light is ON what number display at screen ,the number should near 250. 2.Please setting the hardness level for A tank to number 04. If it still doesn’t work, could you please ...
Why doesn't my chiller work?
Please kindly help us confirm the following information: 1.Could you please kindly advise us the current temperature of water and the temp you set? Because the set temperature must be 5° lower than the actual water temperature for the chiller to work ...
Can this ice maker machine work with the ice box separated?
Yes. This will work. The machine head can work alone. Just make sure you can place a platform to support the top onto the larger binding.