Why the Frost Formation on the Ice Tray or Irregular Ice Formation

• Related Articles

• Why the"Ice Full" Display on Startup

  "Ice Full" Display on Startup Causes and Solutions: 1.If the ice full switch is not properly secured, reattach it. 2.If the ice diverter panel has fallen or is incorrectly installed, adjust and reinstall it. 3.If both the ice full switch and ice ...

• Why is my ice maker showing E4 not making ice？

  E4 Refers to de-icing timeout fault. 1.Is the ice making time adjusted normally? 2.Is there the air coming out of the heat dissipation port to see if it is hot. If it is warm air, there should be no fluorine leakage. You can ask him to press the ...

• Placement Environment Requirements for Ice maker

  Placement Environment Requirements Commercial Ice Machine Placement Environment Requirements: I. Space Requirements The commercial ice machine should be placed in a well-ventilated area. This helps the ice machine dissipate heat, preventing ...

• Why is the ice cubes from my ice maker too thick?

  1. The ice making time may be set too long. Press the down button to adjust the ice making time a little shorter. There is no specific time, this is related to the ambient temperature. The factory time is set to 0 by default. Adjust the time ...

• Why my ice maker can not make ice when I used it first time?

  If you can't make ice for the first time, you have to eliminate them one by one. 1. Is there water flowing after turning on the machine. 2. Is there fluorine leakage. 3. Is the ice making time setting correct. In addition, if the machine stops ...