Why is my ice maker showing E4 not making ice？
E4 Refers to de-icing timeout fault.
1.Is the ice making time adjusted normally?
2.Is there the air coming out of the heat dissipation port to see if it is hot.
If it is warm air, there should be no fluorine leakage. You can ask him to press the upward button and adjust the time to 04 to try and see if there is any ice.
If the air coming out is warm, not hot, and the time is adjusted to 04 but there is no ice. Then it may be fluorine leakage. You can contact our Customer Support at Service@callsupports.com to solve this problem.
Related Articles
Why my ice maker can not make ice when I used it first time?
If you can't make ice for the first time, you have to eliminate them one by one. 1. Is there water flowing after turning on the machine. 2. Is there fluorine leakage. 3. Is the ice making time setting correct. In addition, if the machine stops ...
Why does my ice maker not make ice but circulate water?
Please kindly help us do the following troubleshooting methods: 1.Check whether the compressor is started 2.Is the ice making time set correctly? Set the ice making time to 0 first and try it out. 3.When working, does the air from the heat ...
Why is the ice cubes from my ice maker too thick?
1. The ice making time may be set too long. Press the down button to adjust the ice making time a little shorter. There is no specific time, this is related to the ambient temperature. The factory time is set to 0 by default. Adjust the time ...
Placement Environment Requirements for Ice maker
Placement Environment Requirements Commercial Ice Machine Placement Environment Requirements: I. Space Requirements The commercial ice machine should be placed in a well-ventilated area. This helps the ice machine dissipate heat, preventing ...
Why is my ice maker not making ice? It was working before, but now it is completely off
Please kindly help us do the following troubleshooting methods: 1. Check whether the reading plate is blank 2. Check whether the power supply is working properly If the reading board is blank and there is no problem with the power supply, Could you ...