Why Normal Display and Water Flow but No Ice Production

Why Normal Display and Water Flow but No Ice Production

Normal Display and Water Flow but No Ice Production

Solutions:

1.If the machine lacks sufficient ventilation space, turn it off and check if the display temperature exceeds 40°C. If it does, pull out the machine, allow it to cool, and restart.

2.If the temperature does not exceed 40°C, check if the fan is operating normally. Additionally, if the machine has been in use for more than 6 months, clean the condenser.

Note:

For Commercial Ice Maker Machine,100lbs/24H Stainless Steel Freestanding Commercial Ice Machine with 33 Lbs Storage Capacity 

SKU: 7031761 [KN-45] 

    • Related Articles

    • Why the Display Shows Water Shortage Protection

      Display Shows Water Shortage Protection Causes and Solutions: 1.Check if the water inlet valve is open and if the water pressure is sufficient and continuous. 2.Check if the ice-making drain is continuously draining water. If so, clean the drain ...

    • Why the"Ice Full" Display on Startup

      "Ice Full" Display on Startup Causes and Solutions: 1.If the ice full switch is not properly secured, reattach it. 2.If the ice diverter panel has fallen or is incorrectly installed, adjust and reinstall it. 3.If both the ice full switch and ice ...

    • Placement Environment Requirements for Ice maker

      Placement Environment Requirements Commercial Ice Machine Placement Environment Requirements: I. Space Requirements The commercial ice machine should be placed in a well-ventilated area. This helps the ice machine dissipate heat, preventing ...

    • Why is there so little water flow into my chiller's tank?

      1. Please clean the water pipes regularly to keep the water flowing smoothly. 2. Strongly twisted water pipes will block water flow. Please adjust the water pipe to ensure smooth flow. 3. Please submerge the entire water pump below the water level. ...

    • Why my ice maker can not make ice when I used it first time?

      If you can't make ice for the first time, you have to eliminate them one by one. 1. Is there water flowing after turning on the machine. 2. Is there fluorine leakage. 3. Is the ice making time setting correct. In addition, if the machine stops ...